- #2006 MACBOOK PRO HARD DRIVE CABLE HOW TO#
- #2006 MACBOOK PRO HARD DRIVE CABLE SERIAL#
- #2006 MACBOOK PRO HARD DRIVE CABLE DRIVER#
- #2006 MACBOOK PRO HARD DRIVE CABLE UPGRADE#
- #2006 MACBOOK PRO HARD DRIVE CABLE PRO#
It’s possible something in the controller failed, that my wife received a faulty unit, or that there were a subset of models shipped that had a known problem.
#2006 MACBOOK PRO HARD DRIVE CABLE DRIVER#
(I since think Apple uses driver settings for hardware while in Recovery designed to maximize compatibility even at the expense of performance, and that has something to do with it.) I’d given up until my friend asked that question. When I upgraded my wife’s computer, it wouldn’t boot into macOS, but it would boot into Recovery on the same drive, which was doubly mystifying. And although this model of Mac features a chipset designed to do handle SATA III, none of three different SATA III-only HDDs worked with it. This is surprisingly difficult to discover online, probably because there was a transition period in which computers shifted to SATA III and many drives were hybrid II/III drives that auto-sensed the controller type, could be set to II or III using “jumpers” (clips on a special area of the drive), or could have drive firmware flashed to II or III compatibility.Ī SATA III-only drive apparently doesn’t just not work with a SATA II controller, but tries to move data and fails intermittently.
#2006 MACBOOK PRO HARD DRIVE CABLE PRO#
The late-2011 MacBook Pro supports SATA III-but Apple included only a SATA II hard drive (HDD), which may have been for cost reasons, but also should have been a clue.ĭrive controllers in a computer are backwards compatible, allowing a SATA III controller to work with a SATA II drive, while the reverse isn’t always the case. Each successive standard is backwards compatible with the previous one and they all use the same physical connector type. SATA I offered a maximum 1.5 gigabits per second (150 megabytes per second) transfer rates II doubled to 3Gbps (300MBps) and III doubled again to 6Gbps (600MBps). (Apple has replaced this with a PCIe bus in modern MacBook Pros.)
#2006 MACBOOK PRO HARD DRIVE CABLE SERIAL#
Until relatively recently and for many years, nearly all desktop and laptop computers used the Serial ATA (SATA) standard in version I, II, or III as the protocol for moving data to and from the computer to a disk drive. (If you can find a 4TB laptop drive that’s no higher than 9.5mm, you’re good.)īut I did find a number of people discussing an issue between 20 related to this and similar models: a drive-interface standard mismatch, despite seeming compatibility. I researched again to make sure there wasn’t a known controller flaw or limitation, and there wasn’t. In the guide, you’ll find all the instructions, as well as links to buy the parts you need.I tweeted about this frustration on my latest failure, and my friend Alanna asked: are you sure this laptop model can accept a 1TB drive? I was sure! Or so I thought. You can see the guide to replacing the SSD is right there. The one caveat to that is if your Mac is old enough to use standard 2.5″ or 3.5″ HDDs, you can buy them anywhere. While you can find hard drive replacement kits through online retailers just by searching, we recommend iFixit because they only stock parts from reputable suppliers so you know you’re not going to get ripped off. They have guides for every Mac model and sell all the parts you need. Rather than walk you through every possible hard drive replacement, if you’ve decided to go it alone, I’m going to hand you off to our friends at iFixit. RELATED: Should You Repair Your Own Phone or Laptop? If you’re not sure you have the technical chops to do it right, you should consider asking a more qualified friend to help, or even going to the professionals. The Mac Pro is designed to have its hard drive replaced easily, while an iMac requires you to remove the entire screen. While it is possible to replace the hard drive on any Mac not listed above, how difficult it is varies wildly with the model. This may change if a third-party manufacturer manages to create a compatible hard drive, but for the time being you’ll need to go to an Apple Store or an Apple Authorized Service Provider if you need your hard drive replaced. MacBook Pro 15″ with Touch Bar (All Models).MacBook Pro 13″ with Touch Bar (All Models).
#2006 MACBOOK PRO HARD DRIVE CABLE UPGRADE#
This means that the Mac models you can’t upgrade the hard drive in are:
#2006 MACBOOK PRO HARD DRIVE CABLE HOW TO#
RELATED: How to Wipe Your Mac and Reinstall macOS from Scratch What Macs Hard Drives Can You Upgrade? This will help you figure out if you can upgrade the hard drive in your Mac, and help you find the right parts. On the Overview tab you’ll see your Mac’s exact model.